Page 24 of 36
12.
Form the leads and install the second of these assemblies into the PCB as R20.
Install the Red/Black Zipcord Power Wires
1.
Cut a 9” length of the supplied 18 AWG red/black zip cord.
2.
Strip ¼” inch of insulation from each of the four ends.
3.
Twist and tin the 4 ends.
4.
Insert one end of the red wire into the VCC terminal from the solder side of the
board and solder it on the component side.
5.
Insert the accompanying black wire into the PGND terminal from the solder side
of the board and solder it on the component side.
Install the Bonded Pair Capacitor Wires
The kit is supplied with a 16” length of 4-conductor (Green, Yellow, Brown White)
bonded wire.
1.
Separate that 4 conductor wire into two pieces:
a.
A Green-Yellow piece.
b.
A Brown-White piece.
2.
Cut the Green-Yellow piece to a length of 15 inches.
3.
Strip ¼” inch of insulation from each of the four ends.
4.
Twist and tin the 4 ends.
5.
Inserting the wires into the solder side of the board, and soldering on the
component side:
a.
Connect the Green wire to the C7LNEG eyelet on the board.
b.
Connect the Yellow wire to the C7LPOS eyelet on the board.
6.
Cut the Brown-White piece to a length of 9 inches.
7.
Strip ¼” inch of insulation from each of the four ends.
8.
Twist and tin the 4 ends.
9.
Inserting the wires into the solder side of the board, and soldering on the
component side:
c.
Connect the Brown wire to the C7RNEG eyelet on the board.
d.
Connect the White wire to the C7RPOS eyelet on the board.
Install the auxiliary heatsink
Refer to Figure 11. Locate the 1” tall piece of heatsink material.
1.
Smear a thin film of thermal compound on the flat side of the 1” heatsink.
Be
careful to avoid cutting yourself as the edges may be sharp.
2.
Attach it to the main heatsink using 3 6-32x5/8”sems screws.
