Dynabrade 61461, Operation And Maintenance Manual

Page: 26 / 34

b. Clean hose to remove any accumulated dust, debris or material recovered.
WARNING:
Be sure to remove any remaining materials after use by rinsing
and cleaning the immersion separator, the baffle system, the
sieve basket and the hose.
c. Check the Coalescing Filter Element (CFE) on a regular basis and replace when
saturated
WARNING:
Do not use the Coalescing Filter Element (CFE) after
removal.
Filter chamber
e. Disengage the latches and remove the powerhead from the filter chamber.
f. Remove filters from the filter chamber.
g. It is recommended that the cloth filters be cleaned regularly. Dirty cloth filters will
reduce the airflow through and reduce the performance of the vacuum cleaner.
The cloth filters can be washed with warm water (no detergents required).
IMPORTANT:
After washing the filters, make sure that they are completely
dry before reinstalling them into the filter chamber. Do not
reinstall the cloth filters if they are still wet.
h. The cloth filters should be replaced every two or three years depending on use.
i. Inspect the cloth filters regularly. If the cloth filters are torn, replace immediately.
A torn filter will allow dust and other materials to enter the motor and may cause
pre-mature wear of the motor
j. The HEPA filter should be replaced yearly, or every two years, depending on the
use. (Refer to section for assembling and replacing the HEPA filter.)
WARNING:
Do not use the HEPA filter after removal.
WARNING:
Keep the power supply cable clean and inspect it regularly for
cuts or cracks
WARNING:
Keep the air supply hose clean and dry.
WARNING:
When carrying out service or repair operations, all
contaminated items which cannot be satisfactorily cleaned, are
to be disposed of. Such items shall be disposed of in
impervious bags in accordance with any applicable regulation
for the disposal of such waste;
WARNING:
Clean regularly the vacuum cleaner surfaces with a damped
cloth to avoid dust accumulation.