14
U S E R G U I D E
|
U V C S S I D E CU R E C O N V E Y O R
Figure 20.
Loosening Drive-Roller Shaft-Support Fasteners
•
Move the Shaft Assembly slightly to realign the Drive Roller and center the Belt. Tighten the bolts when
adjustment is complete (Figure 21).
Figure 21.
Tightening Drive-Roller Shaft-Support Fasteners
•
Turn the Conveyor on and adjust the Belt-Tension Knobs (Figure 12) until the Belt is properly tightened. Make
sure that the Belt runs in the center of the Conveyor on both the Loading and Unloading Ends. Repeat this step as
necessary to align the Belt.
•
Reinstall the Pinch Guards on both ends of the Conveyor (Figure 22). This step is critical to Belt-Speed Sensor
operation. The Pinch Guard on the Unloading End of the Conveyor contains a Shield for the Sensor to prevent
damage if the Belt contacts it while operating.
Figure 22.
Installing Pinch Guard (front & back)
