10
Dymax ECE Series UV Flood-Lamp Systems User Guide
Figure 3. ECE Series Flood-Lamp System Components
System Interconnection
WARNING!
Always observe safety requirements when working with electrical equipment!
Electrical hazard is present!
Ensure that the power supply AC cord is unplugged before starting system interconnect.
NOTE:
The only tool required for this procedure is a Philips-head screw driver.
Set-up and operation of your ECE system should be in a location that allows free air circulation around the
sides and top of the Power Supply and Reflector Housing. 12 inches (30.5 cm) of space is recommended.
Once an appropriate location has been determined, follow the instructions below to connect all system
components.
1.
Take
the ECE ZIP™
Shutter and carefully place it on the top of the Light Shield.
2.
Install the Securing Brackets to the top of Light Shield with the M4 x 8 mm screws provided.
NOTE:
Do not tighten until directed to in Step 7.
3.
Place the 400 watt Bulb into the Reflector Housing. Refer to the Bulb Replacement/ Installation
section of this manual for complete instructions.
4.
Install the Mounting Plates to the Reflector Housing. See specific instructions below.
5.
ECE 5000
–
First place the Mounting Plate (Figure 4) and then the Air Plenum (Figure 5) for the
ECE 5000 onto the Reflector Housing. Attach all three components together with four new
M4 x 25 mm screws.
This should result in the assembly shown in Figure 6.
(4) ECE Power Supply
(2) Interconnection Cable, CE
(5) ECE Light Shield
(7) Goggles
(1) ECE Reflector Housing (ECE 5000 Shown)
(3) Power Cord
(6)
ZIP Shutter
(9) Footswitch
(8) Interconnection Cables
