Dymax WIDECURE UV Conveyor
11
SYSTEM ADJUSTMENTS
SETUP SCREEN
The setup screen allows you to set the blower on
and off delays. Blower delays are factory set and
should not be modified without consulting the
factory. This screen also allows you to reset the
lamp hours when a new lamp is installed.
To access the setup screen from the main
screen, hit the Setup UV Button. This is a
password protected screen. The factory preset
password is 321.
Figure 17.
Setup Screen
MAINTENANCE
The conveyor should require little maintenance. It is important
that the Belt be operated under proper tension and alignment.
If it is loose the Belt can slip resulting in Belt and Roller wear
and improper conveyor speed. If the alignment is incorrect,
the Belt can track to one side inducing wear to the side of the
Belt and the Rubber Roller Guides. The conveyor should be
inspected daily to assure that the Belt and Rollers rotate in
phase with one another and that the Belt remains relatively
centered between the two Rubber Roller Guides.
If the Belt requires an adjustment, loosen the Jam Nut and Set
Screw and turn the Adjustment Screw clockwise to increase
Belt tension. Make this adjustment equally on both sides of
the conveyor to ensure proper Belt tracking. Retighten the
Jam Nuts and locking Set Screws. Do not over-tension the
Belt. Over tensioning can cause tearing of the Belt seam and
damage to other components.
If you remove the high-voltage Irradiator Cable from the Irradiator, use care when replacing it. If the Connector is
not properly seated and tightened, the Irradiator Cable can be ruined by arcing across the Connector.
BELT TRACKING ADJUSTMENT
All Dymax WIDECURE conveyors are adjusted at the factory to provide proper tracking of the Belt. Should
further adjustments become necessary, this is done via two Adjustment Screws located at the input end of the
conveyor. To adjust tracking, simply tighten the side to which the Belt is tracking.
CAUTION:
Do not over tighten the Belt. This will lead to accelerated degradation of the Belt.
Figure 18.
Adjustment Screws for Belt Tension
and Alignment
