Attaching the Visor
1
Moisten the ends of the visor posts.
2
Push the left visor post into the round
hole on the left side of the mask.
3
Push the right visor post into the hole on
the right side of the mask.
4
Push the center post of the visor
through the center hole in the top of the
goggle frame until it reaches the first stop ring.
[See figure 1]
5
The visor can be adjusted by pushing the center post to the
second stop ring.
Note: The gap between the visor and the top of the goggle frame is normal.
Changing the Strap
The strap is easily removed from the goggle frame. In ordinary use
and maintenance, it is necessary to remove the strap from the goggle frame.
The lens may be changed with the strap still attached to the goggle frame.
The goggle frame may be cleaned with the strap attached to the goggle.
Tip: Strap removal and installation is much easier when the goggle is at room temperature.
The material is not flexible when it is cold.
Remove the Strap
1
Hold the mask firmly in your left hand.
2
Grasp the strap retainer with your right hand and tilt it straight upward.
3
Twist the strap retainer firmly to remove it.
[See figure 2]
19
Install the Strap
WARNING:
The right and left strap attachment clips are not the
same. The back of each clip is marked either “L” for left, or “R” for
right. Make sure that the Dye logo on the strap faces up. When
properly installed the top of the strap attachment clip is flush with the
top of the goggle frame. It is much easier to install the strap clip into
the goggle frame if the lens is already in the goggle frame.
1
With the strap lying in the palm of your hand, hold the strap clip
between thumb and forefinger.
2
Moisten the bottom tab on the strap clip.
3
Insert the top tab of the strap clip into the slot on the goggle frame.
4
While pushing upward on the top of the strap clip, push the lower
part of the strap clip into the goggle frame.
5
Look inside the goggle frame and confirm that both ends of the strap
retaining tab are completely through the goggle frame.
6
Tug the strap firmly to ensure that the tabs are seated.
Note: It is not easy to install the strap clip into the goggle frame.
Changing the Strap Continued
1
2
20
