Page
18
Figure 5-2
3.
If the weight of the display monitor causes the Tilter Mount Bracket to fall, you may need to adjust
the Tilter Mount Bracket joint to suit your display monitor tilt position of +/- 90 degrees. This can
be done by using Hex Allen Wrench 4mm
(9)
. To increase the resistance of the Tilter Mount
Bracket to secure tilt position, adjust the Tension Hex Socket Cap Screw M5x15mm located
around the Tilter Mount Bracket Joint using the 4mm Hex Allen Wrench (
See Figure 5-2
).
4. To increase or decrease the resistance of the Pivot Joint to suit display monitor swivel, adjust the
Tension Hex Socket Cap Screw M5x15mm located on the Tilter Mount Bracket Joint to secure the
position (
See Figure 5-3
).
5. To increase the resistance, tighten the M5x15mm Tension Hex Socket Cap Screw using Allen
Wrench 4mm
(9)
in a clockwise direction. To decrease the resistance, loosen the M5x15mm
Tension Hex Socket Cap Screw using Allen Wrench 4mm
(9)
in a counterclockwise direction.
Figure 5-3
