D3000
Series
–
User
Manual
–
D3000
‐
USER
‐
EN/09F/v2
‐
6
Basic operations
There are four green indicators above the “Quick Set” keys ([
A
], [
B
], [
C
] and [
D
]) to indicate
whether the system is ready to set. Your Installer will explain which of these indicators are
applicable to your system.
Silencing the system
If the system is emitting an alarm tone, it is possible to silence it by entering your user code
followed by the [
OK
] key
OR
by presenting your tag at a keypad. The display will show the
source of the alarm (e.g. which door has been opened). Rectify the problem, or contact your
Alarm Company for further advice.
Setting all or part of the system
Press the [
Esc
] key and confirm that the green indicators above the Quick Set keys are on.
If they are not, that part of the system is not ready to set, so wait a few seconds. If they
don’t light up, check that all doors in that area are closed.
To set all of the system, enter your user code followed by the [
OK
] key
or
place the tag
against the keypad.
OR
To part set the system, enter your user code followed by the appropriate Quick Set key, or
place your tag against the keypad and press the appropriate Quick Set key twice within 3
seconds.
Leave through the exit route and ensure that all doors are secured behind you. When you
hear the characteristic three beeps, the system is set.
Unsetting the system
Always enter the building via the correct entry route to avoid setting off the alarm. The
intermittent tone indicates that the system is in entry mode. Go straight to the keypad and
enter your user code followed by the [
OK
] key or place the tag against the keypad to unset
all of the system. Alternatively, enter your user code followed by a Quick Set key ([
A
], [
B
],
[
C
] or [
D
]) to unset specific group(s). The red indicators above these keys will go out
showing that the appropriate group(s) have unset.
•
If you proceed into the building without unsetting the correct groups, you will set off
the alarm!
Unsetting the system after an alarm
Always enter the building via the correct entry route to avoid setting off the alarm. Your
Alarm Company may have adjusted your system to start the internal sounders or to use the
intermittent tone to indicate that the system is in entry mode. The internal sounders will alert
you to an alarm occurring during the previous set period.
Go straight to the keypad and enter your user code followed by the [
OK
] key or place the tag
against the keypad to unset all of the system. Alternatively, enter your user code followed by
the appropriate Quick Set key ([
A
], [
B
], [
C
] or [
D
]) to unset specific group(s). The red
indicators above these keys will go out showing that the appropriate group(s) have unset,
but the green indicators will not light for the group which caused the alarm condition. The
display will show details of where the alarm occurred.
•
If you go into the main building without entering your user code, you will set off the
alarm!
