Dyaco ST95-YT007, Service Manual

Page: 19 / 82

S
S
e
e
r
r
v
v
i
i
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
-19-
RUN MODE
SAFETY KEY : When safety key is pulled away from its position, the computer will be automatically shut down.
STOP button : press “STOP” button to stop treadmill.
START button: non-functional.
ENTER button : non-functional.
FAST button: Press the button to increase your speed and each increase is 0.1kph(0.1mph). If button is pressed continuously then speed
increases to MAX SPEED quickly.
SLOW button : Press the button to decrease your speed and each decrease is 0.1kph(0.1mph). If button is pressed continuously then speed
decreases to MIN SPEED quickly.
UP button: Press the button to raise position and each increase is 1, the maximum incline position is 12.
DOWN button : Press the button to lower position and each decrease is 1, the minimum incline position is 0.
SPEED RAPID button : Speed will set to 1,2,4,6,8,10. quickly.
INCLINE RAPID button : Incline will set to 2, 4, 6, 8, 10,12 position quickly.
Fan button : It can to control ON/OFF for the fan(Optional).
DISPLAY KEY
： ： ： ：
You could select the profile of SPEED or INCLINE by pressing DISPLAY key when selecting the programs (P0~P5, U1~U2).
Press DISPLAY key to switch the exercise data shown on the message window when you are workout. At the end of the display cycle, there is
a SCAN MODE, where system will scan and display information automatically every four seconds. The information displayed is as follows:
PROFILE NAME
PACE XX:XX
INCLINE 1~15
LAPS XX
VERT XXXX FT
/ M
SEG TIME X:XX
MAX SPEED XX.X （ only in HRC MODE will not show this string ）
DATA SCAN
（
Display two seconds
）