The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed
for example. To enter the Maintenance Menu (may be called Engineering Mode, depending on
version) press and hold down the
Start
,
Stop
and
Enter
keys keep holding the keys down for about 2
seconds and the
Message Window
will display “Engineering Mode”. Press the
Enter
button to access
the menu below. Rotate the Level knob to navigate the menu, then press Enter.
A.
Key Test
- Will allow you to test all the keys to make sure they are functioning
B.
Display Test
- Automatically tests all LCD’s
C.
Functions
- Press
Enter
to access settings, use
Level knob
to scroll
i.
ODO Reset
- Resets the odometer
ii.
Units
- Choose from English(Imperial) or Metric display readings
iii.
Display Mode
- Turn off to have the console power down automatically after 30 minutes of
inactivity
iv.
Motor Test
- Continually runs the tensioning gear motor
v.
Manual
- Allows stepping of the gear motor
vi.
Pause Mode
- Turn on to allow 5 minutes of pause, turn off to have console pause indefinitely
vii.
Key Tone
- Turn on or off the beep sound when a key is pressed
D.
Factory
Set
E.
Exit
- Select to exit Maintenance Menu
