10
Dyaco
Canada
Inc
2017
Speed Sensor Transmitter Battery Installation
1. Remove the battery cover from the transmitter.
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
3. When new batteries are installed in the transmitter or console you must perform the
synchronizing procedure below for the console to work properly.
Installing the speed transmitter:
Make sure to route the speed sensor wire behind the frame member. Plug the sensor wire into
the transmitter as shown below
Install the transmitter, at the angle shown below, onto the pre-installed Velcro strip located on
the back of the chain cover. Make sure the sensor wire connection is at the top left when
mounting the transmitter.
Make sure the sensor wire is routed away from the spinning flywheel
Synchronizing the transmitter to the console:
1. After installing the batteries, and before attaching the console and transmitter to the bike,
you must synchronize the two, so they can “talk” to each other.
2. Press and hold the two keys on the front of the console for about 3 seconds until the
display shows ID - -
3. Now press and hold the blue button on the transmitter for 3 seconds and release. The
console display should show ID 0. NOTE: You must press the blue button within 10
seconds after the console is showing ID - - otherwise the console will show: ID ER. If the
console shows this error, then restart the procedure again.
4. It may be necessary to remove and reinstall the batteries in both the console and
transmitter if you continue to receive an error.
