Customer Service 1-888-707-1880
Dyaco Canada Inc. 2014
Email: [email protected]
37
Troubleshooting
I. Engineering Mode
1. Remove the safety key
2. Press and hold down the START and Fast (speed up) buttons and replace the safety key. Continue
to hold the START and Fast keys until the window displays all segments.
3. You will now be able to set the display to show Metric or English settings (Kilometers VS. Miles). To
do this, press the FAST/SLOW key to show which you want, then press ENTER.
4. Make sure the wheel size diameter is 2.83 then press enter ( Use FAST/SLOW key to modify)
5. Adjust the minimum speed to 0.5(Miles) and then press enter
6. Adjust the maximum speed to 12.0(Miles) and then press enter
7. Adjust the maximum elevation to 15 and then press START.
8. Press START to begin calibration. The process is automatic and to exit when calibration is finished.
The speed will start up without warning, so do not stand on the belt.
II. What to do when error occurs
1.
LS1:
Missing speed signal
To clear:
Check and make sure that speed signal connector is properly connected.
2.
Err:
Incline motor error
To clear:
Check and make sure that the incline motor cable is properly connected and resume power
to clear error message.
3. E2
: EEPROM memory
error
To clear: replace new PCB
