KENWOOD
13-Pin DIN Accessory Port Connector -
TGR-SL-CAB13K
Our 13-pin cable works with ALL Kenwood radio's that have a 13-pin Accessory Port
, however there are two possible jumper
settings. If your radio is not listed in Figure 1 or Figure 2, then you will need to try both jumper settings to determine which PTT
configuration your radio requires. We suggest that you try the settings in Figure 1 first.
Your radio will NOT be damaged if you install
the PTT jumper using the wrong configuration - you just won’t be able to transmit!
After you have installed the jumpers, be sure to
set the sound card audio levels as outlined in the SignaLink manual. If you do not set the levels correctly, then the SignaLink may not
transmit, and you might mistake the problem for incorrect jumper settings.
Figure 1
Figure 2
Notes
TS-2000
users should set Menu 50F to 1200
Baud. Menu 50B can be used to increase the
radio's power output if it is too low. We suggest
that you change these menu items even if they
already appear to be set correctly. Set 50B to
zero, and then to five. Set 50F to 9600, and then
to 1200.
To increase the Receive Audio Level
on the TS-2000, you can adjust menu 50C.
TS-570
users should set Menu #33 to 1 or 2 (a
setting of zero will result in no transmit
power). Menu #34 should be set at 4-5 and can
be increased to provide more Receive Audio if
needed.
TS-940
users need to use the jumper settings
shown in figure 1, except for the PTT
jumper. The PTT jumper should be connected
to pin #4 instead of pin #3.
TS-440
users please note that your radio's Mic
Gain control will affect your power output. We
suggest setting this control to 50% and then
adjust it as needed so that the SignaLink's TX
knob can be used to adjust the power output
properly.
This configuration is the most common
and works with early Kenwood radios such
as the
TS-140, TS-450S, TS-870
and
TS-
950.
Some newer radios such as the
TS-
570D, TS-590S, TS-940
and
TS-2000/X
also use these settings.
This configuration is less common and is
used by some newer radios (
TS-690
for
example) and some older radios such as
the
TS-440
. These settings are identical
to those in Figure 1, except for the PTT
jumper, which has been replaced by a
diode module (supplied with cable).
* Can use the SLMOD13K Jumper Module for Kenwood radios that have the 13 Pin Din Accessory Port
Connector -
See additional notes in Module Jumper section
MIDLAND
4-Pin Round Mic Connector -
TGR-SL-CAB4R
Radio Models
Pin-out
Notes
JP-1
13-510
Pin 1 – Mic Input
Pin 2 – GND
Pin 3 – N/C
Pin 4 – PTT
