YAESU
5-Pin DIN Packet Connector -
TGR-SL-CAB5PD
Radio Models
Pin-out
Notes
JP-1
FT-920
*
FT-1000
***
FT-1000D
***
FT-1000MP##
FT-1000MPMKV**
FT-1000MPMKV-Field**
FT-2000
FTDX-5000/D/MP
FTDX-9000/D/MP
Check the SLMOD5PD
Jumper Module List
Pin 1 – Data In
Pin 2 – GND
Pin 3 – PTT
Pin 4 – Data Out
Pin 5 – NC
*On the FT-920, the AFSK/FSK switch MUST be set
to AFSK, and you must be in "Data" mode (push the
front panel "Data" button). The Mic Gain control
appears to affect the operation of the Packet jack, so
we suggest setting this to 50% and then adjusting as
needed..
**The FT-1000MPMKV and FT-1000MKV Field
MUST be in "Packet" mode (NOT USB!) for digital
operation. For PSK31 or other "USB" digital modes,
you'll need to set your radio's "User Mode" (selection
8-6) to "PS31U". This will configure the radio to look
at the Packet jack and use the correct side band for
PSK31. For more detailed information on this
(including settings for other modes), see "Digital
Modem Operation" in your radio manual.
***The 5-pin DIN jack on this radio supports only FM
and LSB, which are not compatible with the majority
of digital modes. We recommend connecting the
SignaLink to the Mic jack instead.
## A link to detailed setup information for this radio is
available on the TigerTronics web site.
YAESU
FT-847 ONLY
3.5 mm Stereo "Data I/O" Jack -
TGR-SL-CABNC
Notes
JP-1
For the FT-847, we recommend that you attach the SignaLink
to the "Data I/O" jack. This jack works for all modes and will
let you keep your microphone plugged into the radio. We do
not stock a cable for this jack however, so you will need to
build your own using one of our un-terminated radio
cables. The picture shows how to wire this cable and install
the jumper wires.
Notes:
1. R1 = 2.7k 1/4 watt resistor, C1 = 0.1uf non-polarized
capacitor
2. To prevent damage to socket JP1, the diameter of R1 and
C1's leads should be no larger than those of the supplied
jumper wires (24 gauge).
3. The wire colors shown are for our un-terminated ("NC"
cable. Other cables may not be wired the same.
Unterminated RJ-45 Cable -
TGR-SL-CABNC
Cable Lengths
3ft Length
SLCAB13I SLCAB13K SLCAB5PD
SLCAB6PM SLCAB8PD SLCABK3
SLCABNC
18 Inch Length
SLCAB4R SLCAB8R SLCABRJ1
2ft Length
SLCABRJ4
