- 6 -
Manual Updates
Every effort is made to supply the latest manual revision with each product. Occasionally a manual
will be updated between the time your DX Engineering product is shipped and when you receive it.
Please check the DX Engineering web site (www.DXEngineering.com) for the latest revision
manual.
Tools Required
Wire Stripper
Soldering Iron and Solder
Utility Knife and Lighter (for rope)
Nut Drivers: 1/4”, 3/8”, 516”
Wrench: 7 mm (for the 80 meter coil strain relief clamps)
Pliers
Gloves (see information on Fiberglass Tubing on page 4)
Hammer (for Tent Peg Ground Stakes)
Assembly
Mounting the BALUN to the BMB BALUN Mounting Bracket
1. The
BMB
BALUN Mounting bracket comes with the hardware required to
mount the BALUN. As shown, mount the BALUN in place on the
Mounting Bracket using the four #6 hex head bolts, eight #6 washers and
four #6 Nyloc hex nuts.
Note: The cupped ends are facing the rear.
