- 7 -
followed by a flat washer, split washer and a hex nut as shown. Note the direction of the wire in the
photo. On the top hex head bolt, install a flat washer, split washer and a hex nut. Tighten in place.
The other end of the wire has a fork lug, is connected to the
ANT+
on the AVA2 as shown below
between the two flat washers. Tighten
in place.
Installing the upper two Antenna Elements
The upper two elements are installed to the antenna element that is in
place on the black mounting plate. 3/8” element fits inside the 1/2”
element mounted to the black mounting plate. Use the #6 hardware
and the included Allen wrench to secure this element in place.
Note:
The head of the socket head cap screws will fit inside of the
larger hole and make contact with the element that was inserted.
The upper 1/4” element fits inside the 3/8” element, Use the #4
hardware and the included Allen wrench to secure the upper element
in place. Install the black vinyl cap in place on the top element.
