50281D-01
DW Windsor
Pindar Road, Hoddesdon, Hertfordshire, EN11 ODX
T: +44 (0) 1992 474600 | E: [email protected]
www.dwwindsor.com
Sheet 2 of 4
LEDs contained within this luminaire shall only be replaced
by the manufacturer, their service agent or similar qualified
person.
Step 1
Pierce rubber film on membrane cable gland with an appropriate tool
such as a philips head screwdriver before attempting cable input
Step 2
Loosen and remove pre-attached 2x M10 screws and 4x disc spring
washers from lantern with 6mm allen key (item 1).
Step 3
To feed the cable into the lantern the cable must go through the entry first
and then through membrane cable gland.
Step 5 (See Step 5A for Side Entry installation instructions)
Loosen 2x M10 grub screws on entry with 5mm allen key (Item 2). Slide
entry on to column (See column table). Tighten grubs screws to 16Nm.
Step 4 (See Step 4A for Side Entry installation instructions)
Fit entry to lantern with supplied fasteners, tightening to 36Nm torque. 4x
Disc spring washers must be installed in the correct orientation.
Note! Ensure entry is aligned to desired mounting angle.
Step 6
Undo quick-release rear latch, and leave the latch in the open position.
Note! Align lantern with area to be illuminated
Kirium Pro Midi Installation Steps | Post Top Entry
The Kirium Pro Range
LED Road Light
Kirium Pro Midi
4x
1
2x
1
2x
2
2
!
