DVTEL TRK-101-P, Installation Manual

Page: 15 / 36

Introduction
3
Item Description
RESET Button For setting the unit factory defaults, setting Technician mode, or resetting the
unit.
LEDs The LEDs indicates several status conditions:

Off: The unit is resetting.

Flashing green (300ms intervals): The firmware is booting.

Flashing green (one second intervals): The firmware has booted
successfully, the encoder is connected to the network, and unit is
operating normally.

Steady red: Failure in the first phase of the boot. Requires resetting the
unit.

Flashing red: Failure in the second phase of the boot. Requires
resetting the unit.

Steady yellow: Reset button was pressed for 5-15 seconds and entered
Technician mode. Requires resetting the unit.

Flashing yellow (500ms intervals): The unit is in Factory Default mode.
To enter this mode, press the Reset button for 15-30 seconds. The LED
changes from steady state to flashing after five seconds. The unit’s
firmware returns to the factory defaults. When finished, the LED
displays flashing green.
Note:
If the LED is pressed for more than 30 seconds, it will flash red,
indicating an error. In this case, disconnect the unit and reboot.
TR+/TR-
RS485 Two-pin terminal block connector to connect an RS-485 cable from and control
a PTZ camera.