DVS SDStationOEM, Installation Manual

Page: 35 / 46

3-3
Installation
2
1
3
I
A
Installation of the Board
With the second step the SDStationOEM is installed in the prepared
computer system. To do this perform the following:
y In the computer system find a free half-length PCI slot.
y Remove the slot bracket of this slot.
y Insert the SDStationBoard without bending it.
y Fasten the SDStationBoard with the screw from the slot bracket.
y
Remove as many slot brackets as you need for the additional
panels, and install the panels: Insert the panels and fasten them
with a screw.
y Connect the cables to the appropriate SDStationBoard interfaces
as shown in the figures of section “Overview of Panels” on
page 2-5. If available, please observe the additional information
given in this section as well.
The SDStationOEM is now connected to your computer system prop-
erly. After this you have to finish the installation.
Finishing the Installation
This step is the last step of installing the SDStationBoard. To finish the
installation perform the following:
y Close the computer casing.
y Connect all cables to the computer again.
y Connect your audio and video equipment to the SDStationOEM
connectors.
The installation of the SDStationOEM as hardware is complete. To
use the board and activate its features you must also install the soft-
ware.
The number of additional panels depends on the features
available for your SDStationOEM.