HD/SD Digital Video Switcher DSC945. User’s Manual
DSC Remote.exe
It is possible to control the DSC945 with a PC using an Ethernet connection. The DSC
Remote software supplied with the switcher needs to be installed on the computer first:
1.
Connect an Ethernet cable between the PC and the DSC945.
2.
Turn on the PC and DSC945.
3.
Placed DSC945 into PC Control mode. To do this press the PC Control button on its
Control Panel .
4.
Launch the DSCRemote software on the PC.
Remote software displays an image of the SDSC945’s keyboard as shown below
The Settings (S) button is located just above the T-Bar in the display above.
When clicked a new window will open:
This Settings window is used to match the software to the IP address of the connected SE-
2800 switcher. If unknown, the switcher’s IP address may be found using the DSC Config
software or found and changed by using the EthernetSetup.exe software.
NOTE: It is not possible to run both the DSC Config and DSC Remote software applications
at the same time.
DVLab
25