DVDO Quick
6R
6x2 4K Ultra HD HDMI Switcher
DVDO-UG-1001-B.01
© 2014 Silicon Image, All rights reserved
22
CEC Enable:
If *checked, Quick
6R
responds to CEC commands such as power on or off.
If unchecked, CEC commands are ignored.
Send Initiate ARC:
Enables the Audio Return Channel from the TV to the main HDMI
output and sends a request to the TV to begin sending audio.
Send Terminate ARC:
Disables the ARC function and sends a request to the TV to exit
ARC mode.
Load FW from USB:
Loads new firmware from an inserted USB flash drive. See the
Updating Firmware
section on page
23
for more information.
Factory Settings:
Resets Quick
6R
to factory default settings; refer to the
Resetting to
Factory Default Settings
on page
25
.
EDID Mode:
Allows setting a fixed EDID.
HDMI 6 Power:
Allows non-MHL mobile devices to charge on port 6 and aids with
compatibility with older devices. When activated, this input always appears to be active
even if the connected source is off. This results in a blank InstaPrevue and PIP window
and the amber input LED is always on. This feature is *Off by default.
*Auto:
When selected, Quick
6R
automatically senses source and display capabilities. Use
this for best compatibility unless you have trouble with a specific device.
Custom:
When checked, one of the two capability choices below can be selected. These
options activate a special mode where all capabilities of attached devices are ignored and
the selected ones are used instead. This feature is *Off by default.
1080P, PCM:
Sends 1080p video and stereo PCM audio EDID capability information to all
sources regardless of their display capabilities.
1080P, HBR:
Sends 1080p video and High Bit Rate (HD) Audio EDID capability
information to all sources regardless of their display capabilities.
When using a custom EDID, this selection overrides any choices in the output setup menu.
