DVDO Quick
6R
6x2 4K Ultra HD HDMI Switcher
DVDO-UG-1001-B.01
© 2014 Silicon Image, All rights reserved
19
Manual:
No auto switching; used when Quick
6R
is controlled externally by the
serial port or by a universal remote.
Scan on Disconnect:
Quick
6R
switches to the lowest numbered active input if
the current source is turned off or unplugged.
*Scan + goto new:
Operates the same as Scan on Disconnect, and also
makes a source that is turned on or connected become the active input.
*Mirror Mode:
Both HDMI outputs display the same audio and video. The maximum
common resolution and audio capability of the two TVs is used.
AVR via Aux HDMI:
This is a special mode that indicates that the AUX output is going to an
AVR primarily to carry audio. In this mode, if the AVR is on, its audio EDID is presented to
the inputs so that the maximum audio capability of the AVR can be used. The Main output
audio is also muted. If the AVR is switched off, the main TV output EDID is presented to the
inputs and main audio is unmuted. This selection allows you to use the TV speakers for
audio in normal situations or turn on an AVR and get full HD audio.
AVR via S/PDIF:
This mode is similar to AVR via AUX HDMI except the connection to the AVR
is via S/PDIF coax or optical. Because audio capabilities and power status cannot be sensed
through S/PDIF, this mode uses a common prestored audio capability common to most AVRs.
This mode also mutes the audio on the main HDMI output. If mirror mode is used, then the TV's
audio capability, which is normally only stereo PCM, is used; the AVR via S/PDIF mode,
however, enables up to full bitstream DTS audio to be delivered to the AVR.
