4
HYDROPHORE
CONTROL PANEL
INSTALLATION, MAINTENANCE and OPERATION GUIDE
4. GENERAL INFORMATION OF THE PRODUCT
4.1 General Specifications of the Product
●
The control board you have purchased is designed based on microcontroller.
●
All of the control operations on the panel are done electronically and stored in memory.
●
The electronic board in the control panel is produced with high-tech SMD material.
●
SMD led lamp and LCD screen with minimum energy consumption are used as indicators.
5. FRONT PANEL DESCRIPTION AND USE
4.2 Technical Specifications of the Product
●
16 Bit microcontroller designed.
●
248Mhz running frequency.
●
2X16 character LCD (Liquid Crystal Display).
●
Auto test feature.
●
Auto test selenoid valve output.
●
3-phase voltage reading and display on LCD.
●
Voltage protection, possibility to enter the lower and
upper settings.
●
Pump current reading and display on LCD.
●
Current protection, possibility to enter the lower and
upper settings.
●
Pump circuit,fault and ready to see the status scrren.
●
Recognition mode to calculate the pump current.
●
Possibility to limit te engagement number of the
pumps 1 hour.
●
Ability to determine the reset time at automatic
resetting.
●
Ability to reset automatically in error cases and to
set the reset number.
●
Automatic-manuel selection.
●
Manuel operation when pressing the test button at
manuel.
●
Protection agains dry operation without floater ans
SSR control.
●
Protection agains dry operation without moment
control.
●
Screen to see all the error conditions.
●
Pressure transmitter input and use.
●
Pressure transmitter to monitor the measured value LCD.
●
To adjust the set pressure value.
●
Tracking the operation time of each pump.
●
The actual run time depends on te co-aging.
●
All pumps belonging to the PTC protection.
●
Waste water to be used as panel (menu option).
●
Waste water panel water leak terminal.
●
Password protection against unauthorized
interference.
●
Fault recording 20 takes memory.
1.
2x16 LCD screen.
2.
Up arrow key to move up in the menu ont main
screen and provides paging.
3.
Down arrow key to move down in the menu
provides.
4.
Set key to enter the menu and used the changes
made in the menu.
5.
ESC key to to return to the menu and the menu
before a transacton is allowed rise.
6.
Automatic run led.
7.
Auto - Manuel select button.
8.
Manual Run button.
9.
Lights when pressure switch is start.
10.
Error lihgt.
TEST
TEST
AT
MN
AT
MN
Auto-2
Pump-2
Auto-3
Pump-3
S2
S3
A2
A3
P-2
P-3
BKP-3
Control Panel
TEST
AT
MN
Auto-1
Pump-1
S1
A1
P-1
1
2
3
4
5
6
7
8
9
10
