Duronic ICM120, Instructions Manual

Page: 65 / 68

65
Problem Possible Cause Suggested Solutions
The ice shovel does
not move ice into the
ice basket.
The water tank is not
on a flat even surface.
Check that the surface the machine
is on is flat and even.
With the machine switched off at
the plug, gently push the ice shovel
using your finger, then press the
power button to restart it.
The compressor
works abnormally
with a buzzing noise
The voltage is lower
than recommended.
Stop the machine and do not restart
it until it’s plugged into the correct
voltage.
Water shortage
indicator light is on.
1. There is no water
2. The pump is full
of air
1. Add to some water until it reaches
MAX position.
2.Press POWER button to restart
the machine.
Indicator lights on
display are not on.
1) No power
2) Blown fuse 1) Turn the power on
2) Replace fuse
The Ice made is too
large and with pieces
sticking together.
Ice of previous cycles
left in the water tray.
Take out the ice under the standby
state.
The ice making
process was correct,
but no ice has come
out.
1. The compressor
has no refrigerant
2. Compressor
damaged
3. Fan motor damaged
Call Duronic Customer Care Team
for advice.
All indicators twinkle
simultaneously.
Water tray is blocked
by ice cubes.
Unplug the power, take out the ice
which blocking the tray, then plug in
the power and press the POWER
button. The machine will restart after
around 3 minutes.
The machine has
been working, but
the water has been
warming up
Solenoid has broken
down
Call Duronic Customer Care Team
for advice
When the ice is full,
the machine does
not display the ICE
FULL icon
‘Ice Full’ sensor is
damaged
Call Duronic Customer Care Team
for advice