Duroflame Batavia T3, Technical Manual

Page: 17 / 43

Page 17 of 43
3.6.3 Change language
You can choose your preferred language using the power buttons.
Confirm the desired language using SET.
3.6.4 Setting the pellet stove
Use this menu for setting three different values: the pellet auger (7.1.4), the blower
(7.1.9) and the convection fan (7.1.10). By default, these values are set to 0%. You
can adjust these values between -50% and +50%.
Note! Adjusting the stove has a major impact on the operation of the pellet stove. Do
not change the values by too large intervals; instead, consult your dealer.
Loading pellets
You can increase or decrease the quantity of pellets here. Pellets have their very
own properties, involving length, type of wood, compression, etc., and you may
need to make some adjustments to your pellet supply. We recommend consulting
your dealer about this.
Vent. Flue gas
This is where you set the amount of combustion air. In addition to the pellet supply,
a suitable oxygen ratio is of main importance for good combustion. We recommend
consulting your dealer about this.
Vent. Air
This is where the speed at which the convection fan (7.1.10) should run is set.
These values only apply if the stove is equipped with a convection fan. Increase this
value if, for example, the stove requires additional cooling or if you wish to disperse
the heat more quickly. It is not recommended to decrease this value to prevent
insufficient cooling of the stove.
3.6.5 Thermostat mode
Use this menu to select the thermostat control for the stove to follow. It should be set
to
‘stove thermostat’. Other functions are not in use.
3.6.6 Blocking keys
This is where you can block keys by pressing the following buttons for 20 seconds:
temperature minus and the
power knop minus
Repeat this operation to release blocking.