MK2 FIXED WINDOW (Optional)
9
Step 1:
Lay out the two window studs (883mm) and Nog
(590mm) on a flat surface. Position Nog and nail
in place using two 75mm nails at each end.
570mm
Step 6:
From the outside of the shed, place glass in Win-
dow Frame. Attach a Glazing Bead (G100) with
three rivets to each side of the Window Frame to
hold glass in place. Pre
-
drilling Glazing Beads is
recommended.
Follow Steps 2
-
5 on page 8.
MK2 DOOR JAMB & CORNER FLASHINGS
Step 1:
Fit Door Jamb Flashing (104) in between Top and
Bottom Plates and hard against Stud. Attach Door
Jamb Flashing with three rivets into Rib on the
outside and three 30mm clouts into studs on the
inside. Repeat with the other Door Jamb.
Step 3:
Fit Corner Flashing (101) over corner Ribs with the top
flush with the top of the Top Plate. Rivet in place with
six rivets, three each side. Repeat with other three
Corner Flashings. When fitting Corner Flashings on
front wall, ensure they are parallel with Door Jambs.
Step 2:
Measure and cut Doorstep Flashing (106) to fit in
between Door Jambs. Position the Doorstep Flash-
ing in between the Door Jambs at bottom of door-
way, nail through top of flashing using three 30mm
Clouts. Repeat with the Overdoor Flashing (105).
