❏
14. Snap one end of the rod onto the steering servo
horn. Snap the other end onto the steering arm. Turn
the transmitter on and center the steering trims. Install
the steering servo horn onto the steering servo as
shown. Then turn the transmitter and receiver off.
❏
15. Install the rod connector into the hole farthest
away from the center on the short servo horn (included).
Note: This hole is slightly enlarged.
Place the small
metal washer and 2mm nut onto the bottom of the rod
connector. Make sure not to over-tighten the nut, the rod
connector must swivel freely. Apply a small amount of
thread lock onto the nut to prevent it from falling off
during running.
❏
16. Locate the small rod with a z-bend at one end.
Install the z-bend end of the rod into the lower hole of
the throttle arm on the carburetor. Turn the transmitter
on again and center the throttle trim on it. Install a set
screw into one of the wheel collars.
NOTE:
Only thread
the set screw in slightly so that the wheel collar will
slide over the throttle linkage rod. Place the metal
wheel collar and the throttle linkage spring onto the
throttle rod (Do not tighten the wheel collar yet). Install
the throttle servo horn onto the throttle servo as shown.
❏
17. Make sure the carburetor is at the idle setting
(refer to the throttle stop screw, page 11), then install
the second wheel collar onto the end of the throttle
linkage rod. The wheel collar should slide up against
the throttle linkage rod connector as shown.
❏
18. Slide the first wheel collar against the throttle
linkage spring, slightly compressing the spring. Tighten
the set screw in the wheel collar.
You should apply a
small amount of thread lock to the set screws in
the wheel collars to prevent them from loosening
during running.
❏
19. Lift the throttle linkage servo horn off of the
servo. Install the remaining z-bend wire from the
bottom into the hole farthest from the center of the
servo horn.
Note:
This hole is slightly enlarged. Slide
the threaded end of the brake linkage rod through the
brake lever.
Rod Connector
Rod Connector
9
