❏
1. Install the air filter onto the carburetor. Using
the included tie-strap, secure the air filter to the
carburetor. Cut off any excess portion of the tie-strap
to avoid interference.
❏
2. Remove the twist-tie from around the receiver
antenna wire. Run the length of the antenna wire
through your fingers to help straighten the wire out,
this will make it easier to get the wire through the
antenna tube. Slide the antenna wire through the
antenna tube. Press the antenna tube into the antenna
mount molded into the top of the radio plate.
❏
3. Frequently, there will be leftover wire protruding
from the antenna tube
Do not cut or coil the
antenna!
Cut two pieces of fuel tubing 1/8" long and
slide them over the outside of the antenna tube and
wire. This is to help hold the excess antenna onto the
tube on and avoid getting the antenna wire cut in a roll
over. Note the placement of the fuel tubing on the
antenna tube.
❏
4. It may be necessary to loosen the radio plate to
remove the receiver battery holder. Install 4 "AA"
batteries (included) into the receiver battery holder in
the configuration molded into the battery holder. Install
the receiver battery back into the receiver battery
holder as shown. Make sure to re-tighten the radio
plate screws once the receiver battery is in place.
RADIO SET-UP
AIR FILTER INSTALLATION
4
FINISHING THE STREET FORCE GP TOURING CAR RTR VERSION (DTXD50**)
