❏
8. Remove the long belt from the diff pulley.
❏
9. Remove the outer 2x8mm screw that attaches the left
(when viewed from the front) front shock to the upper
suspension arm. NOTE: Be careful not to lose the shock
spring or shock end when removing them.
❏
10. Remove the left front upper hinge pin that holds the
upper suspension arm to the front gear box.
❏
11. Remove the two 2.6x8mm flat head screws that
secure the lower front suspension arm to the main chassis.
NOTE: Be careful not to lose the ride height spacer
located below the lower suspension arm.
❏
12. Remove the long belt from the front differential pulley.
❏
13. Install the short belt onto the front differential pulley.
❏
14. Re-install the ride height spacer and lower
suspension arm onto the main chassis, securing them in
place with the two 2x8mm flat head screws previously
removed. NOTE: Make sure you get the front dog bone
installed into the differential drive cup before securing
the lower suspension arm to the chassis.
❏
15. Secure the upper suspension arm to the front
gearbox using the previously removed upper hinge pin.
❏
16. Re-install the shock onto the suspension arm,
securing it in place with the 2x8mm screw.
❏
17. Install the short belt onto the rear differential pulley.
❏
18. Re-install the two 2.6x8mm flat head self-tapping
screws into the rear pod.
❏
19. Re-install the upper plate onto the main chassis using
the previously removed screws.
Ride
height
spacer
6
