❏
1. Remove the wheel cover from the wheel. You can do
this by using a small screwdriver and gently prying the
wheel cover from the wheel.
❏
2. Remove the three small Phillips head screws from
the wheel.
❏
3. Rotate the wheel to the desired location.
❏
4. Re-install the Phillips head screws in the new location.
❏
5. Re-install the plastic wheel cover onto the wheel.
❏
6. Make sure both sides are set the same for optimal
performance.
NOTE: A micro servo and optional short belt are
required to run the 140mm wheelbase.
❏
1. Detach the front of the rear shock from the upper plate
ball stud.
❏
2. Remove the two 2.6x8mm flat head self tapping screws
that attach the upper plate standoffs to the main chassis.
❏
3. Remove the two 2x8mm pan head self tapping screws
that hold the front of the upper plate to the front gearbox.
❏
4. Remove the upper plate from the chassis.
❏
5. Remove the shock ball stud located on the upper plate
and re-install it in the hole #2 located directly in front of the
stock mounting hole (#1).
❏
6. Remove the two 2.6x8mm flat head self tapping screws
that secure the rear axle to the main chassis.
❏
7. Slide the rear axle assembly to the short position.
Hole #2
Hole #1
CHANGING WHEELBASE (LENGTH)
TO FIT OTHER BODIES
CHANGING WHEEL TRACK (WIDTH)
5
