Repair service is available anytime.
•
After the 90 day warranty, you can still have your Micro
Street Force repaired for a small charge by the expert at
DuraTrax's authorized repair facility, Hobby Services, at
the address listed on the front cover of this manual.
•
To speed up the repair process, please follow the
instruction listed below.
❏
1.Under most circumstances return the ENTIRE system:
vehicle and radio. The exception would be sending in a
Stress-Tech part. See the instruction and Stress-Tech
Guarantee.
❏
2. Make sure the transmitter is turned off and all of the
batteries are removed.
❏
3. Send written instructions which include: a list of all
items returned, a THOROUGH explanation of the
problem, the service needed and your phone number
during the day. If you expect the repair to be covered
under warranty, be sure to include a proof of date of
purchase (your store receipt or purchase invoice).
❏
4. Also be sure to include your full return address.
All pictures, descriptions and specifications found in this
instruction manual are subject to change without notice.
DuraTrax maintains no responsibility for inadvertent errors
in this manual.
❏
1. Remove the Micro Street Force from the box.
❏
2. Charge the included 6-cell battery with the included
wall charger. Connect the 6-cell NiCd battery to the
connector on the wall charger. Plug the wall charger into a
standard household 110V power outlet. The battery should
not be left on the charger longer than 3 hours. If at any time
during the charge the battery becomes warm to the touch,
it should be removed immediately to prevent damage to
either the battery or the charger. Note: The battery is fully
charged when it becomes warm to the touch.
❏
3. Install the transmitter antenna by screwing it into the
hole on the top of the transmitter. Give the top of the
antenna a light tug to make sure that it is properly secured
to the transmitter.
❏
4. Slide the battery door on the bottom of the transmitter
open. Install eight (8) “AA” batteries into the transmitter in
the configuration molded into the plastic on the battery
holder. Re-install the battery door.
FINISHING THE MICRO STREET FORCE
SPECIFICATION & DESCRIPTION CHANGES
REPAIR SERVICE
3
