❏
4. Remove the two (2) 4-40 x 3/4" socket head machined
screws from the upper plate and rotate the front of the truck
forward. (Note: Be careful that you do not loosen any of
the steering assembly parts during this process).
❏
5. Install the steering servo into the mounting slot. Line up
the holes in the servo mounts with the two holes in the chassis.
(Note: there are two different mounting holes in the servo
mounts. Use the appropriate holes for your servo). Install the
two (2) 4-40 x 5/16" flat head machined screws through the
bottom of the chassis into the servo mounts. Attach the
steering link ball cup onto the 4-40 ball stud on the servo.
❏
6. Install the servo brace onto the chassis using the two (2)
4-40 x 3/8" socket head machined screws and two (2)
4-40 x 3/4" socket head cap screws. Re-install the two (2)
4-40 x 3/4" socket head cap screws into the upper plate.
❏
1. Install the receiver onto the chassis as shown. Remove
the protective backing from one side of the included 1/4" thick
piece of foam tape and install it onto the chassis. Then
remove the other piece of protective backing and install the
receiver onto the foam rubber.
❏
2. Route the receiver antenna through the holes in the
chassis as shown above. Locate the antenna tube, and
thread the receiver antenna through the antenna tube. The
antenna will be longer than the antenna tube. DO NOT CUT
Route the antenna
through the chassis
and then through
the tube.
RECEIVER INSTALLATION
5
