13
To convert the Delphi Indy car so that the battery runs
inline with the chassis use the following steps.
❏
1. Remove the battery end holders (21) from the main
chassis (38).
❏
2. Install (1) of the battery end holders (21) directly in front
of the upper plate support (8).
INLINE BATTERY PLACEMENT CONVERSION
GEAR DIFFERENTIAL
❏
1. Locate the rear axle (45) and install the right wheel hub (47) onto the end with the flat spot farthest from the end of
the shaft. Install and tighten the 3mm set screw (O) in the right wheel hub. Note: Make sure the set screw is tightened
onto the flat spot of the rear axle.
❏
2. Install the diff inner (28) onto the right wheel hub (47). Make sure the hex in the diff inner (28) keys onto the hex on
the right wheel hub (47).
❏
3. Install the (4) diff internal bevel gears (27) into the spur gear (26).
❏
4. Install the spur gear assembly onto the right wheel hub (47) so that it meshes with the already installed bevel gears
(27). Note: The raised inner portion of the spur gear should be away from the diff internal bevel gears.
❏
5. Insert the plastic bushings (30) into the ends of the diff outer.
❏
6. Install the diff outer (29) onto the right wheel hub.
❏
7. Install the axle and differential assembly through the rear pod. The differential should be located on the same side
as the motor pinion (the right side when viewing the car from the rear). Note: Make sure the bearings are still fully
seated after the axle is installed.
❏
8. Secure the axle assembly into the pod by attaching the left wheel hub (46) to the left side (when viewed from the
rear) of the axle. Secure the left wheel hub (46) to the axle using a 3mm set screw (O). Note: Make sure the set screw
tightens down onto the flat spot on the axle.
