D. Roof panels
(4) Roof Panels
(
RP
)
(2) Facia Panel Left
(
FPLB
)
(2) Facia Panel Right
(
FPRB
)
(2) Ridge Cover
(
RRS
)
(64) Roof Plugs w/Washer (
PPG
)
(64) Roof Pins
(
PIN
)
(8) Sagging Support
(RS14B)
Parts Needed:
(2) Roof Panels
(
RP
)
(1) Ridge Cover
(
RRS
)
(16) Roof Plugs w/Washer
(
PPG
)
(16) Roof Pins
(
PIN
)
(4) Sagging Support
(RS14B)
Parts Needed For Each Extension:
3
. Start attaching the
roof panels
from
(FPLB)
corner side by sliding the
roof panel (RP )
to
roof structure. Locate the hole positions of the
roof panel and roof structure. Fix roof plugs with
washers. Use a hammer to drive in
roof pins.
See
figures
1
thru
6.
Add two roof panels for each extension.
1
. Place
facia panel (FPRB)
to front roof structure
right side
.
2
. Line up the holes with roof structure and fix the
roof
plugs
w/
washers
. Use a hammer (rubber mallet) to drive
in
roof pin.
See
figures 1, 2
and
3
for details. Place
facia
panel left (FPLB)
to the front roof structure
left side
.
Make sure
(FPLB)
overlaps on
(FPRB)
. Repeat action to
fix
facia panels
on backside. See Fig. 4, 5 & 6.
Insert roof plugs into roof panels
only as indicated.
Note
29
4
. Attaching the
ridge cover
(RRS)
on top of the
roof panels
(RP )
start from the front side of the
shed. See
Fig.7 Fig.8 Fig.9
Add one ridge cover for each extension.
First insert all roof plugs with washers
to the panels (left & right) then drive
in the roof pins.
TIP
Fig.1
Note
Do not insert Plugs
at this point.
FPLB
KEY
Roof Plugs
FPRB
Fig.3
FPLB
FPRB
Fig.1
Front
Fig.2
FPRB
Front
FPRB
Fig.6
FPLB
FPRB
Fig.4
Back
Fig.5
FPRB
Back
Front
Back
Use a screw driver to align the
holes.