Durafly P-51D OLD CROW, Assembly And Operation Instructions Manual

Page: 17 / 28

14
FINAL ASSEMBLY AND SET-UP PROCEDURES
THE TRANSMITTER AND MODEL SETUP
Before getting started, rebind your receiver with your transmitter if necessary.
CAUTION: To prevent personal injury, DO NOT install the propeller assembly onto the
motor shaft while testing the control surfaces.
TIPS: Make sure all control sticks on your radio are in the neutral position (rudder, elevator,
ailerons) and the throttle in the OFF position. Make sure both ailerons
move up and down (travel) the same amount. This model tracks well when the
left and right ailerons travel the same amount in response to the control stick.
1. Move the controls on the transmitter to make sure aircraft control surface move
correctly. See diagrams below. If controls respond in the opposite direction reverse
the direction for operation of flight controls. Refer to your transmitter’s instructions
for changing direction of transmitter flight controls.
Bank Left
Bank Right
Climb
Descend
Yaw Left
Yaw Right
Aileron
Elevator
Rudder /
Steering