Durafly ME-163 V2, Instruction Manual, Page: 8 / 26

PB1.7X12mm
2
1
5. Following the illustration above, screw the a control horn to the rudder control surface, once
again, a small amount of foam contact glue can be applied to the base of the horn. With the
servo at 90 degree’s (neutral), connect the push rod to the servo arm (outer hole) then to the
control horn and clip the clevis in place.
6. Apply a reasonable amount of glue to the base of the vertical
stabilizer
and then just a small
amount to the lower side edges (1). Wait for about 30 seconds to to allow the glue to become a
little tacky then install the
stabilizer
in place as shown (2), wipe any excess glue away.
5