Durafly ME-163 V2, Instruction Manual, Page: 12 / 26

SETTING UP YOUR MODEL:
1. With your receiver installed and all servos plugged into their corresponding channels (follow the
instructions provided by your radio manufacturer for ‘Delta’ or ‘Elevons’ set-up procedures). Connect
the flight battery to the ESC to power up the electronics. With the model now armed, ensure all
servos are centered and the rudder control surface is neutral as shown. If not, adjust by turning the
control clevis’s by hand accordingly.
Note: For safety reason, please remove the prop before arming your model during the set-up stage.
2. Owing to the design of the Me-163, a small amount of up ‘reflex’ is recommended in the ailerons
to improve all round flight handling. To add reflex, simply adjust the aileron clevises until each
surface has approximately 1-2mm of ‘up’ (when measured from the neutral trailing edge of the wing)
as shown below.
Rudder Neutral
- mm up ‘reflex’
- mm
- mm
9