Durafly Curtiss P-40N, Instruction Manual

Page: 9 / 40

2.7x30mm
2.7x25mm
6. Attach the wing to the fuselage and ensure the servo wires from the wing pass through only the 3rd
hole from the rear of the plywood tray into the fuselage. This will ensure the wing sits correctly on the
fuselage. Once in place, screw the wing firmly down using the screws provided as shown below.
7. Push each of the propeller blades fully into the slots of the spinner back plate. Note that the
numbered sides of the blade face outwards. Secure each blade to the back plate using the 2.6x8mm
screws as shown. Check that the distance between each blade tip is equally. If not, loosen adjust
and tighten again.
6
2.6x8mm