background image

www.tsicustomerservice.com

A517

3

IMPORTANT INSTRUCTIONS

SAVE THESE INSTRUCTIONS

  When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to

       persons including the following:

1.  Read all instructions before using this appliance.

2.  This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this

  appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from

  the front of this appliance and keep away from the sides and the rear.

      WARNING: In order to avoid overheating, do not cover the heater.

3.  CAUTION: Never leave the heater operating unattended. Extreme caution is necessary if unsupervised children or invalids are nearby.

4.  The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and

  knowledge, unless they have been given supervision or instruction.

5.  Always unplug this appliance when not in use.

6.  Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or damaged

  in any manner.

7.  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to

  avoid a hazard.

8.  Do not use outdoors.

9.  This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate this appliance where it may

  fall into a bathtub or other water container.

10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and

  where it will not be tripped over.

11. To disconnect this appliance, turn controls to the off position, then remove plug from outlet.

12. Connect to properly grounded outlets only. This heater is for use on 120 volts. The cord has a plug as shown at A in Fig.1. Do not use a 2

      prong adapters.  Never use with an extension cord or relocatable power tap (outlet/power strip).

13. This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with

  the current CSA C22.1 Canadian Electrical Code or for U.S.A. installations, follow local codes and the National Electrical Code,

  ANSI/NFPA NO.70.

14. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or

  damage the appliance.

15. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where opening

  may become blocked.

16. This appliance has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used

  or stored. This fireplace should not be used as a drying rack for clothing. Christmas stockings or decorations should not be hung in

  the area of it.

17. Use this appliance only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electric

  shock or injury to persons.

1.   Read all instructions before using this appliance.
2.   This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving
       this appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet 

       (0.9 m) from the front of this appliance. 

      WARNING: In order to avoid overheating, do not cover the heater. 
3.   CAUTION: Whenever the heater is left operating and unattended, extreme caution is necessary if children or invalids are nearby.
4.   The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of 
       experience and knowledge, unless they have been given supervision or instruction.
5.   Always unplug this appliance when not in use.
6.   Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or 
       damaged in any manner.
7.   If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order 
       to avoid a hazard.
8.    Do not use outdoors.
9.    This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate this appliance where it 
       may fall into a bathtub or other water container.
10.  Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas
       and where it will not be tripped over.
11. To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
12.  Connect to properly grounded outlets only,  See Fig.1. Do not use a 2 prong adapters. 

13.  This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, 
       with the current CSA C22.1 Canadian Electrical Code or for U.S.A. installations, follow local codes and the National Electrical 
       Code, ANSI/NFPA NO.70.
14.  Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or 
       damage the appliance.
15.  To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where 
       opening may become blocked.
16.  This appliance has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are
       used or stored. This fireplace should not be used as a drying rack for clothing. Christmas stockings or decorations should not be 
       hung in the area of it.22.  Use this appliance only as described in the manual. Any other use not recommended by the 
       manufacturer may cause fire, electric shock or injury to persons.
17.  Always plug heaters directly into a wall outlet/ receptacle. Never use with an extension cord or relocatable  power tap (outlet/

       power strip).

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury 
to persons including the following:

2

A

B

Fig.1

SAVE THESE INSTRUCTIONS

Summary of Contents for 10ILH100-01












Reviews: