-
9
-
SECTION 2 — INSTALLATION INSTRUCTIONS
2.5 REMOUNT BODY AND BODY GUIDES
Install Z Iongmembers. Cut off front of longmemeber, if necessary, to hold 3” (76.20 mm)
clearance between longmember and back of cab. Mount Iongmembers to outside (as shown),
if possible. If longmember are mounted to inside, hinges must be shimmed so that side move-
ment of long members is restricted to 1/8” (3.04 mm). Install grease fittings in hinges.
Install crosshead shaft through pick up plates of longmembers and upper end of links. Bolt in
place.
Remount body so that it is square on the chassis, has the proper cab clearance and fits
snugly into Z longmembers. If wood longmembers on body, bolt to Z longmembers with 1/ 2”
(12.70 mm) carriage bolts (not furnished). If steel longmembers, bolt to Z longmembers with
1/2” (12.70 mm) capscrews (not furnished), or weld body longmember to Z longmembers.
Locate body guides at a convenient location close to cylinder trunnion. Drill (4) 41/64” (16.25
mm) holes in chassis rail, using holes in body guide as a template. Bolt in place.
2.6 VENTING OF SYSTEM
WHEN ANY WORK IS TO BE DONE ON BODY OR HOIST AND
BODY IS FULLY OR PARTLY RAISED, IT MUST BE BLOCKED
SECURELY SO IT CANNOT FALL. IN ADDITION, DISENGAGE
THE PTO AT SUCH TIME.
READ AND STUDY OPERATION SECTION OF ANUAL BEFORE
PROCEEDING.
Raise body slowly until cylinder is fully extended and block body securely. Remove vent plug from
top of cylinder and refill cylinder if necessary. Raise and lower the body several times until air is
eliminated from the system. Recheck oil, observing Warning precautions. With body raised the
oil level should be 2" (50.80 mm) to 3" (76.20 mm) below the fill hole in the cylinder. Add oil, if
necessary. Replace vent plug.
Keep dirt out of system.
2.7 DECALS
Place WARNING and CAUTION decals on instrument panel in plain view of operator and on
body and hoist. See goldenrod sheet B72952-1275 for placement.
CAUTION
!
