-
12
-
SECTION 3 — OPERATION
3.1 GENERAL
Before operating this hoist, see capacity chart (Figure 1) and read warningand caution de
-
cals on instrument panel, body, and hoist. See goldenrod sheet B72952-1275 for decals and
placement.
WHEN OPERATING DO NOT STAND IN, MOVE THROUGH,
OR ALLOW ANYONE ELSE TO STAND IN OR MOVE
THROUGH THE AREA THAT YOUR HOIST OPERATES AND
PASSES THROUGH, ORINTO AN AREA THAT AN UPSET
LOAD MIGHT FALL.
3.2 DEFINITION OF AN OPERATOR
An operator as referred to herein is a competent person who has read and un-
derstand the "Operation and Maintenance Manual".
3.3 POWER TAKE-OFF OPERATION
1)
Mechanical Transmission
—To encourage PTO, place transmission shift lever in NEUTRAL.
—Set hand brake.
—Depress clutch pedal.
—Shift PTO into gear.
—Release clutch pedal.
Equipment is now ready to operate.
2) Allison Transmission
—To engage PTO, stop the truck and set the hand brake.
—With the Allison transmission in any gear position, engage PTO.
NOTE: If gears do not mesh, it may be necessary to let the truck creep slightly in
in gear while putting a slight pull on the PTO control.
—After PTO is engaged, move transmission shift lever to NEUTRAL.
Equipment is now ready to operate.
—To disengage PTO, move transmission shift lever into any gear position and
shift PTO out of gear.
—Move transmission shift lever to NEUTRAL.
Truck is now ready to move.
CAUTION
!
