Installing the Threshold
1. Cut Threshold to 35-1/2”. Notch for In-swinging or Out-swinging door, as shown. Install with 1/4” plastic
lag shields and #10 X 1-1/2” fl at phillips screws, unless Threshold is installed on a wood deck, in which case,
omit plastic lag shields.
2. Attach Corner Brace to Bracket with (2) 1/4-20 X 1- 1/2” bolts with locking nuts.
Do not tighten at this
time.
3. Swing the free end of Brace to Enclosure Side Wall and position Bracket on
Side Wall Stiffener Angle where holes in Bracket and holes in Brace are aligned.
4. Attach Corner Brace Bracket to Stiffener Angle as shown. Use (2) #12 X 3/4” self drilling screws. Drill
one 5/16” hole inside Wall Stiffener Angle to align with hole in Corner Brace Bracket. Place Corner Brace in
position and install and tighten all locking nuts on 1/4-20 X 1-1/2” bolts.
Threshold for Outswinging Door
Both sides of the Threshold are to be notched the same.
Threshold for Inswinging Door
Both sides of the Threshold are to be notched the same.
Page 19
Treads should
always
be to the
outside.
End view of
Threshold
3/8”
13/16”
1/2”
1/2”
3/8”
2”
Summary of Contents for Deluxe Three -Season Sunroom
Page 4: ...Page 3 Room Assembly...
