Page 10
Installing Starter Panel
1. You can begin installing Wall Panels
at either Right or Left Wall Channel.
This instruction starts at the Right
Wall Channel with the Right Starter
Panel.
This panel has a Panel Frame
on one edge, start the other edge
(without the Panel Frame) into the
Wall Channel. Seat the Panel in the
Floor Channel. Do not fasten Starter
Panel in Wall Channel at this time.
2. Following your Project Planner, insert
Panel Frame of the next Panel into
the Panel Frame of the fi rst Panel just
installed. Insert to the stops of the Panel
Frame. Fasten Panel Frame at top,
center and bottom of both inside and
outside of Panel Frame using #8 x 1/2”
self-drilling screws.
Do not
install
screws in Floor Channel at Panel Frame
until Corner Joiner has been installed.
View from
inside
Enclosure
1. Before installation of the Door Panel, the Floor Channel Side Walls must be cut for the Door opening.
As indicated below, the door hinge side of the Floor Channel is cut slightly larger to accommodate the door
swing. Locate Door Panel and mark sides of Floor Channel accordingly. Remove Door Panel and cut side
walls of Floor Channel as marked.
2. Continue installing Panels by positioning each Panel, or Corner Joiner, so its legs will slide over legs of
Panel already in place.
3. Illustration on next page shows Enclosure Side Wall installed. View from top shows Frame overlap. Door
Panel(s) will install in the same way shown for Window Panels.
View from
outside
Enclosure
Wall
Channel
Top View of
Right Wall
Starter Panel
Home Wall
2”
2”
Center of
Panel
Starter
Panel
Floor Channel
Wall
Channel
Page 10
Summary of Contents for Deluxe Three -Season Sunroom
Page 4: ...Page 3 Room Assembly...