40
Setting the trimming position (When set to [Trim On])
This is the finished length after trimming.
When the paper length is entered, the standard trimming
position will automatically be displayed.
The standard trimming width is 3 mm/0.12 inch.
∗
Standard trimming position: (Paper length
÷
2) – 3 mm/
0.12 inch (MAX: 253 mm/9.96 inch)
Here, it is displayed as “102.0/4.02” (210
÷
2) – 3 = 102.0/
(8.27
÷
2) – 0.12 = 4.02.
If not changing this value, proceed onto the next step.
To change the finished length, press the box
1
to reset
the value displayed to 0, and enter the desired value.
Range of input: 75.0 to 253.0 mm/2.95 to 9.96 inch
(Trimming width within 75 mm/2.95 inch)
Press the [Return key] to confirm the value.
Pressing the box again while entering the value returns
the original value.
After entering the trimming position, press the [Next key]
to proceed to the <Confirm Settings> screen.
Pressing the [Back key] returns to the <Enter Paper Size>
screen.
102 . 0
1
Next key
Back key
<Set Trimming Position> Screen
Trimming width
Step
3
The stitching width is displayed.
The stitching position interval is displayed.
When the paper width is entered, the standard stitching width will automatically be displayed.
∗
Standard stitching width: (Paper width
÷
2) mm/inch
Here, it is displayed as “148.5/5.85” (297
÷
2 = 148.5/11.69
÷
2 = 5.85).
When paper width is below 140 mm/5.51 inch, stitching width will always be 70 mm/2.76 inch.
To change the value, press the box
3
, and enter the desired value.
For corner stitching, enter the value “Paper width –30.0 mm/1.18 inch” (stitches at the 15.0 mm/0.59 inch position
from the side edge of the paper).
Range of input: From 70.0/2.76 (Paper width –28.0 mm/1.10 inch)
Press the [Return key] to confirm the value.
After entering the paper size, press the [Next key] and proceed to the <Confirm Settings> screen.
If set to “Trim On”, proceed to the “Set Trimming Position” screen.
As paper size is restricted according to binding conditions, the machine will not proceed to the next step if the paper size
entered is not appropriate.
Pressing the [Back key] returns to the <Select Binding Mode> screen.
Confirming settings
210. 0
x
297 . 0
210. 0
x
297 . 0
Back key
Return key
<Confirm Settings> Screen
Step
4
Make sure that the values entered are all correct, and then
press the [Return key] on the touch panel.
Pressing the [Return key] saves the settings of the
memory number and returns to the <Main Menu> screen.
Pressing the [Back key] returns to the <Set Trimming
Position> screen if set to “Trim On”, and returns to the
<Enter Paper Size> screen if set to “Trim Off”.
7. SIDE STITCHING/CORNER STITCHING PROCEDURES
