Duplex Jet Vac Compact, Instruction Manual

Page: 19 / 32

JET VAC
COMPACT
Hour counters
The device is equipped with two hour counters, one resettable by the user and one non resettable. To
visualize the hours, switch the device off by using the button (10), subsequently press the button (12),
every time you press this button you can read the respective partial hour counter and total hour counter.
Reset of the partial hour counter
Switch the device off by using the main switch (8) located in the front of machine, press both “Power /
Stand-
by” (10) and “Boiler” (12) switches and hold them, switch the device on by using the main switch
(8), once finished the LED lights sequence, release the switches and the hour counter C2 will be brought
to 0000.
Indication of boiler cleaning operation (C A L C )
The controller has been programmed to warn the user about the ordinary maintenance period; the system
has been programmed in order to warn each 30 effective working hours (steam solenoid valve on).
Proceed as described in the section 8 “Maintenance of the boiler” in order to perform the liquids drainage.
Warning indication (C A L C ) restoration
After having performed the maintenance, switch the device off by using the “Power / Stand-by” switch (10),
press and hold for 10 seconds the “Boiler” switch (12). The warning C A L C will be restored.
Pressure visualization
With the unit being turned on press and keep pressed the “Boiler” button (12), after some seconds the
display will show the value of the pressure in bar inside the boiler, this data will remain visible on the
display for 10 seconds, afterwards the value of the temperature in °C will appear again.
Power save mode
The p
ower save mode permits to reduce the unit’s consumption after 1 hour of inactivity. For activating or
deactivating such mode it is enough to switch the generator off by pressing and holding for 10 seconds the
“Power / Stand-by” button (10), the display will show alternately T-ON or T-OFF depending on the
previously selected setting.
Refilling of detergent :
Once the detergent tank is empty, proceed as follows:
1. Add diluted detergent into the tank (19).
2.
Switch the device on, by pressing the “Power / Stand-by” switch (10) and the “Boiler” switch (12).
3. Activate the detergent switch (35), press and hold the steam command switch (36A) until detergent
starts coming out from the tool.
4. Detergent has been trigged and the machine is now ready for use.
16 JVC 44/15