PREPARATION
PROTECT YOUR EYES AND EARS. WEAR ANSI Z87.1 SAFETY
GLASSES WITH SIDE SHIELDS. WEAR HEARING PROTECTION.
EMPLOYERS AND USERS ARE RESPONSIBLE FOR ENSURING THE
USER OR ANYONE NEAR THE TOOL WEARS THIS SAFETY
PROTECTION.
This roofer is supplier with a Milton 727 type air coupler. If another
type coupler is required, use a free flow quick connect fitting on the
tool. (See Fig. 1)
Add a few drops of part number 403720 pneumatic oil into the air inlet.
(See Fig. 2)
Empty the nail and cap magazines.
Connect the tool to an air compressor using a 3/8” I.D. hose. Make
sure the hose has a rated working pressure exceeding 200 PSI and a
female quick coupler. (See Fig. 3)
Regulate the air pressure to obtain 80 PSI at the tool. Check the
operation of the contact safety trip mechanism following the
instructions in this manual. (See Fig. 4)
Disconnect the air supply from the tool.
Load nails into your tool following the instructions in this manual. (See
Fig. 5)
Load caps into your tool following the instructions in this manual. (See
Fig 6)
Reconnect the air supply to the tool.
Test for proper nail penetration by driving nails into a sample piece of
wood. If the nails do not achieve the desired penetration, check that
pressure is adjusted to at least 100 psi. Then adjust depth stop on back
of roofer until desired penetration is reached. (See Fig. 7) Do not
exceed 120 PSI at the tool.
Set the Switch at the top of the tool “On” for cap feed or “Off” for
applying roofing nails only. (See Fig 8)
(3)
1.
2.
3.
4.
5.
6.
7.
8.
