4. Using On-Screen Menu
75
NOTE:
• When [HDBaseT] is set, the projector goes into the [SLEEP] mode regardless the setting for the standby mode (
→
page
) on the
on-screen menu is [NORMAL] or [NETWORK STANDBY]. Based on this, the projector can be powered ON by an HDBaseT transmission
device that is connected to the projector when the projector is in the standby mode. However, the standby mode setting cannot
be changed when [HDBaseT] is set.
• While [HDBaseT] is set for the [SERIAL PORT], power consumption in the standby mode becomes not to satisfy the energy saving
regulation.
TIP:
• When controlling the projector using the LAN port, this works with either setting.
Turning On or Off Remote Sensor [REMOTE SENSOR]
Set the remote control sensors on the projector’s front and rear panels and the HDBaseT remote
control sensor.
The options are: [ALL], [FRONT/BACK], [FRONT], [BACK], and [HDBaseT].
TIP:
• If the remote control system does not function when direct sunlight or strong illumination strikes the remote control sensor of the
projector, change another option.
• The remote control sensor on the back of the projector cannot be used when the separately sold cable cover is mounted on the
projector.
Setting ID to the Projector [CONTROL ID]
You can operate multiple projectors separately and independently with the single remote control
that has the [CONTROL ID] function. If you assign the same ID to all the projectors, you can conve-
niently operate all the projectors together using the single remote control. To do so, you have to
assign an ID number to each projector.
CONTROL ID NUMBER
Select a number from 1 to 254 you wish to assign to your projector.
CONTROL ID
Select [OFF] to turn off the [CONTROL ID] setting and select [ON] to turn on the [CONTROL ID]
setting.
NOTE:
• When [ON] is selected for [CONTROL ID], the projector cannot be operated by using the remote control that does not support the
CONTROL ID function. (In this case the buttons on the projector cabinet can be used.)
• Your setting will not be affected even when [RESET] is done from the menu.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control ID.
