35
Replacing the projection lamp
The lamp hour timer in the About menu counts the number of hours the
lamp has been in use. After 1,980 hours, the message “Change lamp” briefly
appears on the screen at each startup. When the timer reaches 2,000 hours,
the lamp will no longer light. You can order new lamp modules. See “Acces-
sories” on page 38 for information.
1
Turn off the projector and unplug the power cable.
2
Wait 60 minutes to allow the projector to cool thoroughly.
3
Turn the projector upside down and remove the lamp door by removing
the two screws and sliding the lamp door tabs out of the three tab bays.
CAUTION
: Never operate the projector with the lamp door removed.
This disrupts the air flow and causes the projector to overheat
.
4
Loosen the captive screw on the lamp module.
About
menu
computer 1
computer 2
video
monitor out
network
serial control
audio in
audio in
audio in
audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in
turn off and unplug
the projector
wait 60 minutes
loosen the screw on lamp module
bail wire
Summary of Contents for 28A8757
Page 1: ...Audio Visual Products USERS MANUAL MODEL 28A8757 ...
Page 2: ......
