11
ENGLISH
L2000651 Installation guide for DucoBox Silent (Revision N | 13.07.2020)
06.E
Pairing components
Never pair more than one system with RF components at the same time. If you do so, a component in the wrong
network could be paired, e.g. in the neighbours’ DucoBox.
Pairing components on the DucoBox Silent
1
Activate ‘Installer mode’ by tapping ‘INST’ on the DucoBox� The LED
will flash green rapidly�
2
Add control components by tapping once on the component to be
paired� The LED will flash red briefly and then start to flash green
rapidly� Repeat this step until all remaining components in the cur-
rent zone have been paired�
With RF components: start with the component closest to the mas-
ter� If the first pairing is unsuccessful, another component may be
tried first, which can then act as a hop point for components which
are unable to make an RF connection with the DucoBox�
3
Once all components have been paired, ‘Installer mode’ can be
deactivated by tapping ‘INST’ on the DucoBox Silent� LEDs on all
components will stop flashing�
Please refer to the manual with the components for more detailed informa-
tion�
06.F
Removing / replacing components
Removing paired components from the network or replacing is only possible within 30 minutes after the component is paired in
or is restarted� Restarting can be done by disconnecting the power for a moment� After a time-span of 30 minutes, remove and
replace operations are ignored� This is valid for all components from date of manufacture
170323
�
Removing a component
1
Activate ‘Installer mode’ by
long-pressing 2 diagonal buttons
on a paired control� The LED will
flash green rapidly�
5 sec
2
Press once and hold a button on
the component to be removed
in order to remove it from the
network�
5 sec
3
Deactivate ‘Installer mode’ by
pressing the 4 buttons on a paired
control simultaneously (or using
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
Replacing a component
1
Activate ‘Installer mode’ by
long-pressing 2 diagonal buttons
on a paired control� The LED will
flash green rapidly�
5 sec
2
Press briefly twice on the button
of the component to be replaced�
2x
OLD
3
Tap once on the button for the new
component� The latter will take on
all settings / connections in the
network�
1x
NEW
3
Deactivate ‘Installer mode’ by
pressing the 4 buttons on a paired
control simultaneously (or using
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
1
2
3
4
5
6
7
8
Example of a pairing sequence
indicates the order in which a
button of the component must be
pressed controls component
X
