35
E
Important
Throughout the running-in period, be careful to stick
to the recommended maintenance schedule and periodic
service intervals indicated in the warranty booklet. Failure
to follow these instructions will release Ducati Motor
Holding S.p.A. from any liability for any engine damage
or shortened engine life.
Keeping to the running-in recommendations will ensure
longer engine life and reduce the need for overhauls and
re-tuning.
Pre-ride checks
Warning
Failure to carry out these checks before starting may
result in damage to the motorcycle and injury to rider.
Before starting, check the following points:
Fuel level in the tank
Check the fuel level in the tank. Re-fuel if necessary
(page 40).
Engine oil level
Check the oil level in the sump through the sight glass.
Top up if necessary (page 60).
Brake and clutch fluid
Check the fluid levels in the respective reservoirs.
Tyre condition
Check the pressure and condition of the tyres (page 58).
Controls
Operate the brake, clutch, gearchange and throttle
controls (lever, pedal and twistgrip) and check that they
function correctly.
Lights and indicators
Check that lights, indicators and horn are working properly.
Replace any burnt-out bulbs (page 51).
Key locks
Check that the fuel filler cap and the seat are locked.
Sidestand
Make sure side stand operates smoothly and is in the
correct position (page 32).
Warning
If there are any faults or malfunctions, do not start
the motorcycle and contact your DUCATI Dealer or
Authorized Service Centre.
Summary of Contents for SPORTCLASSIC GT 1000
